clear

Sign In

your password
check_boxKeep me signed in

Can't access your account? | Register

phone04-586 6681
assignment_indRegister
shopping_cart
Untitled
Untitled
Untitled
Untitled

BROWSEchevron_rightRESIN, FILLERS AND SEALERSchevron_rightDoming Resin

Epoxy Doming Resin and Hardener | 30 Litres 30 Litres DR030

Downloads

We pride ourselves on giving the best quality, brands and service. So if for any reason you're not happy with your purchase; contact us and we will do our best to rectify the problem.

Epoxy Doming Resin and Hardener | 30 Litres

NORSKI
DR030
5+
$930.01
favorite_borderAdd to Favorites
Add To Cartexpand_lessexpand_more

20L Epoxy Doming Resin + 10L Hardener = 30 Litres

Epoxy Doming Resin is a two-pot Epoxy Resin formulated for use in the following areas: top-coating decorative wooden tops, wooden plaques, badges, cold epoxy enamelling and decoupage.

Preparation and Application:
1. Use a clean dry container, add two parts Base to one part Hardener (2:1), stir until the materials are thoroughly blended together, mixing should be completed after two minutes of vigorous mixing.

2. The importance of thorough mixing cannot be over emphasized - if bubbles are whipped into the mixture these can be removed later. Note: Improper mixing can result in soft/sticky spots.

3. Once you have thoroughly mixed the resin mixture, carefully pour over the surface in an even pattern, spread where necessary using a piece of stiff paper to help the liquid flow together.

4. lf the mixed Doming Resin is left in the mixing container, it will become hot and set rapidly.

5. After the Doming Resin has been applied to the article, any air bubbles created while stirring will rise to the surface taking approximately five minutes to appear, these bubbles can be easily broken by gently using a propane torch.

6. Hold the torch approximately 150mm away from the article and sweep smoothly across the surface until the bubbles have disappeared; this process may be repeated as often as is necessary while the material is still in liquid form. Brush the edges until the material has set firm enough not to sag.

7. It is the carbon dioxide, not the heat which breaks up the bubbles. 

Cure:
1. For the best results, coat at temperatures between 22degC and 28degC.

2. Allow the coated item to cure in a warm dust free room.

3. Cure time will vary with humidity and temperature, humidity below 50% is recommended for proper hardness of the film.

4. Placing a clean cardboard box over the item is effective in keeping dust off the surface during the curing cycle.

Temperature Dust Free Cure Time
- 22degC 4-7 hours 72 hours
- 28degC 3-6 hours 48 hours
- 32degC 2-5 hours 36 hours

Let's Talk

WE ARE HERE TO ASSIST YOU, PLEASE GET IN TOUCH.

Join Our Mailing List

GET UPDATES ON OUR LATEST NEWS & OFFERINGS.